[fink:package-submissions] #4910 wip-2p3-2007 (depending on gcc6)

"Remko Scharroo" <[email protected]>
Newsgroups gmane.os.apple.fink.tracker
Message-ID </p/fink/package-submissions/4910/2642502c578cb9a6c4c4d447190b892536a14bb4.package-submissions@fink.p.sourceforge.net>
You are right, Hanspeter. wip should depend on pgplot with gcc6, i.e. I updated to Depends line to pgplot (>= 5.2.2-13).
In addition, I tried with readline7, which works fine.
The updated wip.info file is attached.


Attachments:

- [wip.info](https://sourceforge.net/p/fink/package-submissions/_discuss/thread/56d8f66f/7b0a/attachment/wip.info) (1.6 kB; application/octet-stream)


---

** [package-submissions:#4910] wip-2p3-2007 (depending on gcc6)**

**Status:** open
**Group:** Awaiting_Update_from_Submitter
**Labels:** sci Updated Revision of Existing 
**Created:** Mon May 08, 2017 03:27 PM UTC by Remko Scharroo
**Last Updated:** Fri May 12, 2017 03:57 AM UTC
**Owner:** Remko Scharroo
**Attachments:**

- [wip.info](https://sourceforge.net/p/fink/package-submissions/4910/attachment/wip.info) (1.6 kB; application/octet-stream)


Update of wip-2p3 to use gcc6 instead of gcc5.
Bumped revision from 2006 to 2007.
Does not affect wip.patch
No warnings using fink -m rebuild wip


---

Sent from sourceforge.net because [email protected] is subscribed to https://sourceforge.net/p/fink/package-submissions/

To unsubscribe from further messages, a project admin can change settings at https://sourceforge.net/p/fink/admin/package-submissions/options.  Or, if this is a mailing list, you can unsubscribe from the mailing list.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Fink-tracker mailing list
[email protected]
http://news.gmane.org/gmane.os.apple.fink.tracker
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.