Re: Ringpipeline funktioniert nicht so wie gewohnt
Thomas Kaegi <[email protected]> Wed, 24 Feb 2016 16:05:14 +0100
| Newsgroups | gmane.os.apple.ragtime.german |
|---|---|
| Message-ID | <[email protected]> |
Zur Info an die Liste: Dieser Fall ist abgeschlossen. Hans-Peter hat mir den Formularblock = geschickt und ich konnte mit der in der ersten Antwort angegebenen = Methode die Sache in Ordnung bringen. Keine Ahnung, weshalb es bei mir = geklappt hat und bei ihm nicht. Hauptsache, es l=E4uft! Thomas Am 24.02.2016 um 14:53 schrieb Prof. Dr. Ing. Rohler Hans-Peter = <[email protected]>: > Hallo, Thomas, >=20 > das habe ich leider schon erfolglos genauso so probiert =85=20 >> Am 24.02.2016 um 14:37 schrieb Thomas Kaegi <[email protected]>: >>=20 >> Hallo Hans-Peter >>=20 >>> Hallo in die Runde=20 >>>=20 >>> In einem ziemlich komplexen Formular habe ich verschiedene Layouts = abgelegt die auf der ersten Seite einen Briefkopf enthalten, auf der = zweiten Seite lediglich eine leere Seite mit Seitenzahl. Beim Erstellen = des Formulars habe ich auf Seite 2 eine Ringpipeline gelegt, so dass ich = dann im folgenden Seite 3 ff automatisch anf=FCgen, sofern ich diesen = Platz ben=F6tige. Das Formular f=FCgt aber nach Seite 2 wieder Seite 1 = mit dem Briefkopf an, was ich nat=FCrlich nicht will =85 hat jemand hier = eine Idee was das Problem ist? >>=20 >> Es sieht so aus, als ob die Pipeline im Formularblock von Seite 2 = wieder zur Seite 1 zur=FCckgezogen worden w=E4re. Ich w=FCrde mal den = Formularblock =F6ffnen und alle Pipelines mit dem = Pipeline-Scheidewerkzeug kappen und danach neu ziehen - von Seite 1 zu = Seite 2 und dann von Seite 2 zu Seite 2 (die Ringpipeline). >>=20 >> Freundliche Gr=FCsse >> Thomas >> ############################################################# >> This message is sent to you because you are subscribed to >> the mailing list <[email protected]>. >> To unsubscribe, E-mail to: <[email protected]> >> To switch to the DIGEST mode, E-mail to = <[email protected]> >> To switch to the INDEX mode, E-mail to <[email protected]> >> Send administrative queries to <[email protected]> >>=20 >=20 > Prof. Dr. Hans-Peter Rohler=20 > f o u n d a t i o n 5 + l a n d s c h a f t s a r c h i t e k t e n = + p l a n e r b d l a >=20 > Karth=E4userstra=DFe 7-9 | 34117 Kassel | Tel. 0561-920 008 23 | Fax: = 0561-920 008 20 | www.foundation-kassel.de >=20 >=20 >=20 >=20 >=20 >=20 > ############################################################# > This message is sent to you because you are subscribed to > the mailing list <[email protected]>. > To unsubscribe, E-mail to: <[email protected]> > To switch to the DIGEST mode, E-mail to = <[email protected]> > To switch to the INDEX mode, E-mail to <[email protected]> > Send administrative queries to <[email protected]> >=20 --=20 Thomas Kaegi T: +41 32 622 1914 Heidenhubelstr. 15 M: +41 79 432 9655 CH-4500 Solothurn ############################################################# This message is sent to you because you are subscribed to the mailing list <[email protected]>. To unsubscribe, E-mail to: <[email protected]> To switch to the DIGEST mode, E-mail to <[email protected]> To switch to the INDEX mode, E-mail to <[email protected]> Send administrative queries to <[email protected]>