RE: [ITP] h8300-hitachi-coff-toolchain

> Forgive me if I missed it, but I don't think you've submitted a ssh key.

Yes, that is correct.  In further testing during the time between the sending
of the ITP email and the subsequent approval, I discovered that some
executables built using GCC 15.1 would encounter strange errors during runtime
and cause the build to fail.  I was eventually able to isolate this to an
error in GCC -O2 optimizations (isseus are not observed with -O1).

While Cygwin GCC package is not yet at version 15, I did want to try to
understand the scope of the issue.  Since then, I have been working to setup
the Cygport Workflow Template on GitHub.  (The process to get to the point of
the GCC-induced error during the build is somewhat long.)  From a maintenance
perspective, this Cygport Workflow Template should also be of help, as the
workflow is also setup to run on a weekly basis, so if any breaking changes
are introduced by newer software versions, they hopefully should be able to be
caught and flagged more quickly.  I also then tested that template with a few
other Cygport packages to hopefully make it a little more robust.

Cygport Workflow Template Repository
 * https://github.com/mesheets/Cygport-Workflow-Template

Examples:
 * https://github.com/mesheets/hello.cygport
 * https://github.com/mesheets/flac.cygport
 * https://github.com/BrickBot/h8300-hitachi-coff-toolchain.cygport
 * https://github.com/BrickBot/nqc.cygport


At any rate, I am hoping to get back to the h8300-hitachi-coff-toolchain
Cygport package process…  :-)


Thank you,
Matthew