Re: [GSOC] Implement hardware nested page table support for vkernels

Sepherosa Ziehau <[email protected]>
Newsgroups gmane.os.dragonfly-bsd.kernel
Message-ID <CAMOc5cxq==LKYY8s_ecWKCx7AUAZE-2n6PtV8vkEyWTBOxCOQQ@mail.gmail.com>
On Mon, Jun 24, 2013 at 3:16 AM, Mihai Carabas <[email protected]> wrote:
> Hello,
>
> I will make a brief description of what I've done this week. First I will
> make a short paragraph with my joy while getting up a new development
> environment.
>
> At the begining of the week I received at my school some HP blades [1], with
> Xeon processors that supports EPT. I decided to move from the Corei3 desktop
> and create a new developing environment. After struggling with the HP iLO
> virtual console, I installed the DFly on it (at first I tried with the
> virtual CD-ROM and it didn't work because dragonfly wasn't recognizing the
> devices, than moved to the virtual USB drive and it worked). After a lost
> day, I managed to install it and have this ACPI warnings[2]. Booting without
> ACPI, failed with a panic [3] (the console has no buffer, so I can't give
> you more output). There wouldn't be any problem (only annoying prints to the
> console), but at a reboot the machine freezes in this state [4]. Yesterday
> swildner came with the notice to put in boot/loader.conf the
> "debug.acpi.disabled="thermal"" and the warning messages dissapeared, but
> the reboot still blocks. Further more, I investigate with swildner and found

As for the reboot issue, there are several things could be tried:
1) on/off sysctl hw.acpi.handle_reboot
2) on/off sysctl hw.acpi.disable_on_reboot
3) don't load ehci module

Best Regards,
sephe

-- 
Tomorrow Will Never Die
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.