at91sam9x35

hi i'm doing eCos porting on board Atmel: at91sam9x35.
Well, now i did the memory mapping on plf_io.h file and then i created all
other file for dbg port. If i try to debug to see if the dbg port works, on
the putty terminal i see something similar to
"G!ÙV@Øt÷TÖåëÅõëõ­õÑfçfçnçf£Qü", but i'd wanted to write "Hello world\n". I
know that this is a possible error of baud rate but the baud rate on putty
and on ecos are correct(115200).
Have you got some ideas about?



--
View this message in context: http://sourceware-org.1504.n7.nabble.com/at91sam9x35-tp225742.html
Sent from the Sourceware - ecos-devel mailing list archive at Nabble.com.