Re: STM32 ROMINT don't run

Hi Samuel

On 23/01/14 18:02, Samuel Charnet wrote:

> John Dallaway wrote:
>
>> You may be observing the following issue:
>>
>>     http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001864
>>
>> Try modifying hal/cortexm/arch/current/src/hal_misc.c to read as follows:
>>
>>> #if defined(CYG_HAL_STARTUP_ROM) || defined(CYG_HAL_STARTUP_ROMINT)
>>> // Relocate data from ROM to RAM
> 
> Thanks for your quick answer.
> 
> I had a hope but it is not enought, it still doesn't run.
> 
> the stack is different :
> 
> (gdb) target remote :3333
> Remote debugging using :3333
> 0x00000000 in ?? ()
> (gdb) c
> Continuing.
> Note: automatically using hardware breakpoints for read-only addresses.
> stm32f4x.cpu -- clearing lockup after double fault
> Program received signal SIGINT, Interrupt.
> 0x00000000 in ?? ()
> (gdb) where
> #0  0x00000000 in ?? ()
> #1  0x08001d3c in Cyg_Exception_Control::deliver_exception
> (this=<optimized out>, exception_number=<optimized out>,
> exception_info=<optimized out>)
>     at /home/lucky/Devel/PLSee/ecos/ecos-3.0/packages/kernel/current/src/common/except.cxx:234
> #2  0x0800005e in hal_default_exception_vsr () at
> /home/lucky/Devel/PLSee/ecos/ecos-3.0/packages/hal/cortexm/arch/current/src/vectors.S:184
> #3  0x0800005e in hal_default_exception_vsr () at
> /home/lucky/Devel/PLSee/ecos/ecos-3.0/packages/hal/cortexm/arch/current/src/vectors.S:184
> Backtrace stopped: previous frame identical to this frame (corrupt stack?)
> (gdb)

If you have not already done so, disable compiler optimisation by
removing "-O2" from the CYGBLD_GLOBAL_CFLAGS option. Also enable
CYGPKG_INFRA_DEBUG. You should then be able to step into your code from
system reset and see where the exception is triggered.

Note that STM3240G-EVAL ROMINT startup is similar to STM32F4-Discovery
ROM startup which is working fine. So I don't think there is a major
problem here. Check all references to "CYG_HAL_STARTUP == ROM" and
"CYG_HAL_STARTUP_ROM". Modify these expressions if the code they control
is also relevant for ROMINT startup.

Good luck with your debugging...

John Dallaway
eCos maintainer
http://www.dallaway.org.uk/john

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss