Re: ecos hardware flow control for just one serial port
Ilija Stanislevik <[email protected]>
| Newsgroups | gmane.os.ecos.general |
|---|---|
| Message-ID | <[email protected]> |
On 06/23/2014 10:35 AM, Oleg Uzenkov wrote: > Dear All, > > I have a custom board with STM32F4 which has multiple serial ports. Is > there a way in eCos to enable Hardware Flow Control for just one > serial port? Or, if enabled, Hardware Flow Control applies to all > serial port drivers? > > Thanks in advance, > > Oleg > Enabling CYGPKG_IO_SERIAL_FLOW_CONTROL and CYGOPT_IO_SERIAL_FLOW_CONTROL_HW only gives you a possibility to use hardware flow control. Then you can use cyg_io_set_config() to activate flow control on particular serial port. Ilija -- Ilija Stanislevik SIvA doo ul. Mladinska 43 lok. 6 p.f. 53 MK-2400 Strumica Macedonia www.siva.mk <http://www.siva.mk> -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss