Please do not reply to this email, use the link below.
http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219
--- Comment #61 from Ilija Kocho <[email protected]> ---
(In reply to comment #60)
> Hello Ilija,
>
> (In reply to comment #59)
> > I was about to commit but in the last check I noticed something that needs
> > explanation.
> >
> > The function hal_stm32x0_led(). I assume there is some conflict with
> > ethernet. Please explain.
> >
> > There must be better solution that deletting 3 leds.
> >
> > 1. Make compilation conditional, so LEDS are in use when possible and
> > ommitted otherwise.
> >
> > 2. Remove this function completely. or replace it with new. (I wouldn't
> > reccommend this).
> >
> > If above assumption is not correct, there may be other solutions as well.
> Sorry I omitted it during checking. This was used by me only for my debug
> purpose. Development board, which I used, has only one LED.
> Please skip this change it's absolutely not needed by driver.
>
For avoidance of doubt: I revert the code for this function to the state before
adding of Ethernet driver.
Ilija
--
You are receiving this mail because:
You are on the CC list for the bug.
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.