Re: FYI: Prime X670-P WiFI built in Ethernet detected and basically operational on main [so: 16]
Mark Millard <[email protected]>
| Newsgroups | gmane.os.freebsd.current |
|---|---|
| Message-ID | <[email protected]> |
On Dec 21, 2025, at 15:37, Mark Millard <[email protected]> wrote: > After my kernel update (pkgbase style) today I noticed that the built-in > ethernet was detected. After the overall update, trying it for some basic > operation looks to be working. (My context is normally limited to basic > operation.) Up to this point I'd been using a USB3 dongle for Ethernet > for this system. > > Extracted from "dmesg -a" output: > > Autoloading module: if_rge > rge0: <RTL8125> port 0xe000-0xe0ff mem 0xdf400000-0xdf40ffff,0xdf410000-0xdf413fff at device 0.0 on pci8 > rge0: Ethernet address: REDACTED > rge0: no link .... > rge0: link state changed to DOWN > rge0: link state changed to UP > Starting Network: lo0 rge0. > rge0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500 > options=9b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM> > ether REDACTED > inet REDACTED netmask 0xffffff00 broadcast REDACTED > media: Ethernet autoselect (1000baseT <full-duplex>) > status: active > nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> > . . . Looks like I coped too much. The following was actually associated with the UBS3 Ethernet dongle having been still plugged in: > rgephy0: <RTL8251/8153 1000BASE-T media interface> PHY 0 on miibus0 > rgephy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto === Mark Millard marklmi at yahoo.com