Re: DS10L - "processor correctable error"

Bernd Walter <[email protected]>
Newsgroups gmane.os.freebsd.devel.alpha
Message-ID <[email protected]>
On Thu, Feb 07, 2008 at 03:40:24PM +0000, Anton Shterenlikht wrote:
> On Thu, Feb 07, 2008 at 03:53:12PM +0100, Bernd Walter wrote:
> > On Wed, Feb 06, 2008 at 12:17:38PM +0000, Anton Shterenlikht wrote:
> > >
> > > "Warning: received processor correctable error."
> > > 
> > > What is the meaning of this warning? Something wrong with hardware?
> > 
> > This is an ECC memory correction.
> > It is OK to see it once in a while, since even 100% working DRAM has
> > failures from time to time (called softerror rate) - therefor the need
> > to have ECC in important systems
> > If however you see a lot of them it is time to replace the faulty
> > memory.
> 
> Bernd, thank you.
> Can I know which DIMM (DS10L has 2 DIMMs) is faulty?

Unfortunately not.
IIRC Tru64 and VMS have support for this, but we never had enough
information to handle this and this is board specific as well.

> If I run SRM memexer I get:
> 
> >>>show_status
>  ID       Program      Device       Pass  Hard/Soft Bytes Written  Bytes Read
> -------- ------------ ------------ ------ --------- ------------- -------------
> 00000001         idle system            0    0    0             0             0
> 000003ab      memtest memory            6    0    0    5586812928    5586812928
> >>>
> Processor correctable error through vector 630.
> 
> Machine Check Logout Frame @ 0x6000 Code = 0x86
> 
> Alpha 21264 IPRs (CPU 0):
> I_STAT:         0000000000000000    DC_STAT:        000000000000000C
> C_ADDR:         00000000296287C0    DC1_SYNDROME:   0000000000000000
> DC0_SYNDROME:   000000000000008F    C_STAT:         0000000000000003
> C_STS:          000000000000000A    MM_STAT:        0000000000000000
> 
> >>>
> 
> The message appears approx. once every other pass.
> The address is always the same.

Don't be worried too much about this.
Alphas are using the memory in pairs and can correct multiple faulty
bits in a single dataword.
However - you could try to remove and reconnect the Modules, since it
can happen that a contact isn't good after that many years.

-- 
B.Walter                http://www.bwct.de      http://www.fizon.de
[email protected]           [email protected]            [email protected]
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-alpha
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.