Re: RockPro64 with latest image fails to boot?

On Thu, 6 Aug 2020 13:46:16 +0200
Søren Schmidt <[email protected]> wrote:

> 
> 
> > On 6 Aug 2020, at 12.13, Emmanuel Vadot <[email protected]> wrote:
> > 
> > On Sun, 2 Aug 2020 11:30:00 +0200
> > Søren Schmidt <[email protected] <mailto:[email protected]>> wrote:
> > 
> >> 
> >> 
> >>> On 1 Aug 2020, at 23.55, Bjoern A. Zeeb <[email protected]> wrote:
> >>> 
> >>> 
> >>> In case you would be willing to try building a kernel yourself, try something with a lot of non-essential modules (e.g. the allwinner modules) removed and see what happens (just trying to make the size of the kernel smaller).
> >> 
> >> Thats where I startet to see the problem, with my own minimal kernel config, to make certain I hadn?t goofed it up I tried the latest stock image.
> >> 
> >> I have tried different SD cards and PSU's to rule those out (and yes it boots every time on a NetBSD image).
> >> 
> >> However from 20+ boots I can say that it dies in different places but close to the original post here. BUT it did manage to boot once (without HDMI).
> >> As the HW boots my older custom kernel just fine (and the other BSD?s) I don?t think its a HW problem, but more likely a race of sorts since it did boot once.
> >> 
> >> The same issue is with my pinebookpro, it behaves exactly the same, but no output on the display at all, just console..
> > 
> > There is no support for eDP in mainline u-boot.
> > Some patches are around to add support but I don't think that they
> > have been submitted upstream.
> > There is another issue with eDP and FreeBSD kernel, u-boot set the
> > CPLL to 600Mhz (iirc) but the DTS have it set to 800Mhz so when we
> > process the assigned-clocks property and set it to 800Mhz the eDP
> > clock (which is derived from CPLL) isn't correct anymore and we lose
> > the display.
> 
> OK, I?ll look around a bit and see what gives.?
> 
> > 
> >> I?ll try to backstep -current to where it did work and se it that brings any light over the issue?
> > 
> > Did you find anything ?
> 
> Yeah VirtualBox managed to crash my Mac into oblivion, so I?m just about finished getting things back together again (timemachine is nice :) )
> 
> However, it also fails with my previously good -current release, so that points pretty squarely at u-boot 2020.07. I?ll try to go back to 2020.04 (plus patches to find 4G etc).

 What patches are you talking about ?

> --Søren
> 
> [email protected] / [email protected]
> "So much code to hack, so little time"
> 


-- 
Emmanuel Vadot <[email protected]>
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"