Re: Pinebook Pro battery fuel-gauge driver..
Søren Schmidt <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On 16 Aug 2020, at 15.02, Emmanuel Vadot <[email protected]> wrote: > > On Fri, 14 Aug 2020 18:23:33 +0200 > Søren Schmidt <[email protected]> wrote: > >> Hi >> >> Now that we have display and all working > > I wouldn't say that, what you have is an hack that will probably cause > other problem. Sure, but havn’t found any ill effects yet, I’ll look into getting it done correctly, but for now it makes the pinebookpro useful and self-contained. >> I hacked up a driver for the cw2015 chip that can tell how much battery is left so I know when to seek an outlet :) >> >> It consists of a patch to the dts (from linux) where all I need is the chiplocation but for compats sake, and the driver. > > Cool, got any link for your code ? Mind to open a review ? Code was attached to the original mail, I’ll look into getting a review setup, need to figure out how that works on fabricator though. >> Access is via sysctl, as we have no real way of handling this info on ARM (no acpi, apm etc) AFAIK. > > thj@ started to split battery subsystem from ACPI a while ago iirc. Any pointers to that ? I admit I didn’t look around too much, considered emulating APM but went with simple sysctl’s. -- Søren Schmidt [email protected] / [email protected] "So much code to hack, so little time" _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"