Re: RPi4B: modern firmware vs. Device tree loaded to 0x4000 (size 0xbe0c) [fails] vs. to 0x1f0000 (size 0xbd90) [works]?
Robert Crowston via freebsd-arm <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <pVDfTV9C_icBNLv2nwUHBdb_KAugcw9cmC2Gw9D4LCp3ujNCHOTtH3kIhlUTpZRlGymrxDaFr8YILkbiUG6cace4KR-k7fKi_IXTvwqzZxU=@protonmail.com> |
> > mmc0 is current device > > should not be mmc0 if you boot from USB/SSD I'm still using sd cards. armstub or not has no effect. Seems like a counter is overflowing in the internals of malloc(). Not even when booting, just when interpreting the bootcmd. I tried raising CONFIG_SYS_MALLOC_F_LEN, but it didn't change much. The malloc() code in question is from 2002, so I doubt it's a bug there. I tried rolling back from HEAD to v2020.10. Same problem. Very weird. — RHC. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"