Re: RPi4B: edk2-platforms updated because _DMA method for XHCI DMA issue insufficient for Linux; pftf/RPi4 v1.21 has the change

Hi Mark,

Does this change affect FreeBSD w/ UEFI in any way?  Should I consider
updating the UEFI bootcode on my board?

Yours,
Robert Clausecker

On Fri, Nov 13, 2020 at 02:55:21PM -0800, Mark Millard via freebsd-arm wrote:
> 
> Quoting https://github.com/tianocore/edk2-platforms/commit/dac891da5cf326d2b4e9aa5adab1d9320b2dd443 :
> 
> Add an IORT table that will limit XHCI DMA to 2 GB, by setting the
> DMA width to 31 bits. This is needed for Linux/arm64, which can
> only reliably deal with devices that are unable to perform DMA to
> the entire 32-bit address range if it can discover their existence
> early during boot, and this is before the ACPI interpreter is up
> and running (which rules out calling the _DMA method of the XHC0
> object)
> 
> End Quote
> 
> https://github.com/pftf/RPi4/releases/tag/v1.21 includes this change.
> (It also updates the RPI4B firmware to quit using the broken start4.elf
> that corrupted Device Tree information.)
> 
> ===
> Mark Millard
> marklmi at yahoo.com
> ( dsl-only.net went
> away in early 2018-Mar)
> 
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-arm
> To unsubscribe, send any mail to "[email protected]"

-- 
()  ascii ribbon campaign - for an 8-bit clean world 
/\  - against html email  - against proprietary attachments
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"