Re: bcm2711-rpi-4-b.dts

Hi Klaus,

With this file and the u-boot binary you linked it appears
to boot.  Sounds good!

Thanks a lot for your support.  Perhaps you could link this file
in the instructions for other people to find?

Yours,
Robert Clausecker

On Wed, Nov 18, 2020 at 05:24:05PM +0100, Klaus Cucinauomo wrote:
> Hi Robert,
> 
> in our German language you asked me in a very friendly and funny private email which 
> bcm2711-rpi-4-b.dts file has to be compiled.
> Here is one which you can try and which works :
> 
> https://reviews.freebsd.org/D26853
> (D26853 :'Bus xhci_pci: probe failed, error -110' will never bring you near to heart attack again, :-) Ha Ha
> you’ll need u-boot 2020.10 and you’ll overwrite the files which have the number 4 in it’s filenames.
> 
> Because you also asked for  Wiki-entry- details :
> It seems many do not know this: The FreeBSD wiki consists mainly of inside information for/from developers, which is often hard to understand for the end user but (hopefully) glass clear to understand for insiders .
> FreeBSD 13/rpi4 is in development and is not yet released, so the Wiki-team cannot guarantee fully working environments based on patches for upcoming releases which are linked in the Wiki .
> 
> Nevertheless, I'm very happy that the Wiki is so useful for you ! ;-) 
> 
> Best Regards
> 
> Klaus  
> 
>  
> > Am 17.11.2020 um 20:05 schrieb Robert Clausecker <[email protected]>:
> > 
> > Hallo Klaus,
> > 
> > 
> > 
> > Schöne Grüße,
> > Robert Clausecker
> 
> 

-- 
()  ascii ribbon campaign - for an 8-bit clean world 
/\  - against html email  - against proprietary attachments
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"