Re: Just getting started with Rasperry PI 4B, 8GB...

Just a quick (top-posted) note as I'm going into a meeting.

I followed these steps:
https://lists.freebsd.org/pipermail/freebsd-arm/2020-November/022701.html

But instead of mdconfig I just dd'ed the image and mounted the SD-card to put the right files in the msdos partition.

Have fun with it. My RPI4 8GB runs quite fine for about 2 weeks now.

Ronald.
 
Van: Thomas David Rivers <[email protected]>
Datum: woensdag, 2 december 2020 03:35
Aan: [email protected], [email protected]
Onderwerp: Just getting started with Rasperry PI 4B, 8GB...
> 
> Hello everyone,
> 
>  I'm looking at getting FreeBSD (a pretty stable version) running
>  on a 4B 8GB... I haven't stumbled over a "how to" write-up, and
>  thought I would sign on to freebsd-arm to see where things stand.
> 
>  I took a gander thru the past 3 months archive postings and I see
>  things might not be working too well in on a Raspberry PI 4B 8GB?
>  But, I'm kinda suddenly swimming-in-the-deep-end here without
>  too much context.
> 
>  I downloaded and imaged the latest (2020-Nov-26) 13.0 image,
>  but it just tells me "This board requires newer software".
> 
>  I haven't gone the UEFI route yet - since I'm just booting an SD
>  card (don't need USB boot from a disk drive.)  
> 
>  My PI 4 - 8GB says:
> 
>    Raspberry Pi 4 - 8GB
>    bootloader: c305221a  Sep   3 2020
>        config: 86697050
> 
>  so the bootloader is pretty new.
> 
>  It's getting
> 
>  Read config.txt bytes      147 hnd 0x000003e3 hash '0370b4dfaea0caaf'
>  recover4.elf not found (6)
>  recovery.elf not found (6)
>  Read start4.elf bytes  2775076 hnd 0x00001ebc hash '0797505a72b169c3'
>  Read fixup4.dat bytes     6193 hnd 0x00001c06 hash '5945fb04d1ba9299'
>  0x00d03114 0x00000000 0x00000000
>  start4.elf is not compatible
>  This board requires newer software
>  Get the latest software from https://www.raspberrypi.org/downloads/
>  ERROR: 00000044
>  Insert SD-CARD
> 
> 
>  I'm guessing there's some obvious step I'm missing here; so perhaps
>  someone already has a write-up about this I just need to look for,
>  if there are any pointers.
> 
>  Or - do I need to switch to a UEFI boot?  Or is a Pi 4B-8GB just
>  not supported yet?
> 
>      - Many thanks! -
>       - Dave Rivers -
> 
> --
> [email protected]                        Work: (919) 676-0847
> Get your mainframe programming tools at http://www.dignus.com
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-arm
> To unsubscribe, send any mail to "[email protected]"
> 
> 
> 
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"