Re: ThunderX Panic after r368370

On 06.12.2020 10:47, Mark Millard wrote:
> 
> 
> On 2020-Dec-6, at 00:17, Michal Meloun <meloun.michal at gmail.com> wrote:
> 
>> On 06.12.2020 3:21, Marcel Flores wrote:
>>> Hi All,
>>> Looks like the ThunderX started panicking at boot after r368370:
>>> https://reviews.freebsd.org/rS368370
>>>  From a verbose boot, it looks like it bails in gic0 redistributor setup(?):
>>> gic0: CPU29 Re-Distributor woke up
>>> gic0: CPU24 enabled CPU interface via system registers
>>> gic0: CPU17 enabled CPU interface via system registers
>>> gic0: CPU29 enabled CPU interface via system registers
>>> done
>>> Full Verbose boot:
>>> https://gist.github.com/mesflores/f026122495c8494d041bce04d30b15bb
>>> I'm not really familiar with the details of the commit, but happy to test
>>> anything if anyone has any ideas.
>>
>>
>> Hi Marcel
>> are you able to get crashdump and do backtrace?
>> https://www.freebsd.org/doc/en/books/developers-handbook/kerneldebug.html#kerneldebug-obtain
>> and
>> https://www.freebsd.org/doc/en/books/developers-handbook/kerneldebug-gdb.html
>> If not, I'll make some debug patch.
>>
>> It's weird, even though GIC is potentially affected by my patch, in this case the cpuid numbering was not changed.
> 
> (I've no access to a ThunderX. I just looked for my own curiosity.
> Sorry if this is obvious and so is noise.)
> 
> When I looked at the code it appeared to be the last "->" in
> the following that was dereferencing the nullptr value (via [x8]
> in assembler notation):
> 
> static uint64_t
> its_cmd_prepare(struct its_cmd *cmd, struct its_cmd_desc *desc)
> {
>          uint64_t target;
>          uint8_t cmd_type;
>          u_int size;
> 
>          cmd_type = desc->cmd_type;
>          target = ITS_TARGET_NONE;
> 
>          switch (cmd_type) {
>          case ITS_CMD_MOVI:      /* Move interrupt ID to another collection */
>                  target = desc->cmd_desc_movi.col->col_target;
> . . .
> 
> In other words: it appeared to me that the above desc->cmd_desc_movi.col
> evaluated as 0 when used in what was reported.
> 
This is very probably right analysis. But problem is that 
cmd_desc_movi.col should not be NULL, is initialized in its_cmd_movi 
from sc->sc_its_cols which should be allocated in gicv3_its_attach().


Marcel, can you, please also try this debug patch?
https://github.com/strejda/freebsd/commit/a25ed736644b05672e3e813891af213c280daac3
Unfortunately, I have only single socket board with GIv3, Honeycomb, but 
it still boots fine.

Thanks, Michal

_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"