Re: Build for Intel iXP420 board?

On Thu, Dec 10, 2020, 3:48 PM Brett Glass <[email protected]> wrote:

> FreeBSD 9 or 10! These are just old enough that I can't find archives. Were
> Avila images ever published in binary form, or would I have to set up a
> development machine, check out old sources, and cross-build?
>

You will need to build your own... you can likely install FreeBSD 9 or 10
an bhyve VM.

Warner

--Brett Glass
>
>
> At 02:25 PM 12/10/2020, Warner Losh wrote:
>
> >FreeBSD 9 or 10 or maybe 11 is your best bet. 'gateworks' I think
> >is what you want to search for in the sources, not avila, but
> >maybe you can use both to find them. The armv5 port was removed
> >from FreeBSD because it had bit rotted too much. I used to run
> >FreeBSD 8 on these boards as a wireless access point shortly after
> >Sam committed the code to the tree. I've had good luck with
> >FreeBSD stable/10 on other arm gear, but there's been reports of
> >issues on stable/10 with unaligned I/O causing problems for some
> >cache topologies.
> >
> >WarnerĀ
>
>
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"