Re: Build for Intel iXP420 board?

Hi.

I tried old arm on FreeBSD. I seem FreeBSD old arm
implimentation is so bad. It's very bad performance.


I suggest you use other OS.

Hiroki Mori


----- Original Message -----
> From: Brett Glass <[email protected]>
> To: Warner Losh <[email protected]>
> Cc: "[email protected]" <[email protected]>
> Date: 2020/12/11, Fri 07:48
> Subject: Re: Build for Intel iXP420 board?
> 
> FreeBSD 9 or 10! These are just old enough that I can't find archives. Were
> Avila images ever published in binary form, or would I have to set up a
> development machine, check out old sources, and cross-build?
> 
> --Brett Glass
> 
> 
> At 02:25 PM 12/10/2020, Warner Losh wrote:
> 
>> FreeBSD 9 or 10 or maybe 11 is your best bet. 'gateworks' I think 
>> is what you want to search for in the sources, not avila, but 
>> maybe you can use both to find them. The armv5 port was removed 
>> from FreeBSD because it had bit rotted too much. I used to run 
>> FreeBSD 8 on these boards as a wireless access point shortly after 
>> Sam committed the code to the tree. I've had good luck with 
>> FreeBSD stable/10 on other arm gear, but there's been reports of 
>> issues on stable/10 with unaligned I/O causing problems for some 
>> cache topologies.
>> 
>> WarnerÂ
> 
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-arm 
> To unsubscribe, send any mail to "[email protected]"
> 

_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"