Updates on 13-STABLE on Apple M1 (Parallel Desktop)
Andrea Brancatelli via freebsd-arm <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Organization | Schema31 s.r.l. |
| Message-ID | <[email protected]> |
Today I've found some time to spend on trying to make 13-STABLE boot on Parallel Desktop on Apple M1 processor. A few weeks ago I wrote that just a while block appeared in the upper left corner and nothing happened. Today out of nowhere I thought about hooking a serial port to the machine and I attached with NC to it. With my great surprise, 13-STABLE was booting OK but wasn't writing anything in console, it seemed to prefer console for reason I cannot say. So I was able to enter in the installer (funny fact, I had to press "enter" in the VM console to have the machine boot but then I had to write in NC to use the installer) and got up to the point where I was trying to ZFS the drive. I could not go after on that because everything I tried when formatting the drive got me cannot zero first 4096 bytes of '/dev/ada0p3': Invalid argument With UFS everything went smoothly and I was able to complete the installation. Yet, no local console... Any general suggestion? Thanks -- Andrea Brancatelli _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"