Re: FreeBSD on RPI Compute Module 3+ 32G
Massimiliano Stucchi <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
Hi, I continue this solo thread with some news, as I spoke too soon. On 25/01/2021 10:43, Massimiliano Stucchi wrote: > > Hi, > > On 04/01/2021 15:03, Massimiliano Stucchi wrote: >> >> I have recently received a turingPi and a bunch of compute modules 3+ >> 32G, and I started playing with them. > <SNIP> >> However, my modules have a 32G built-in eMMC, and the boot just turns >> into a series of timeouts related to the MMC. > > I'd like to report that with the new 13-ALPHA2 images and the latest > DTD, the module boots up and works fine. I was able to boot, to configure everything and run it for a while. As long as you don't cut power to the module abruptly, it works. It has already happened to me twice that, after simply removing the module from its socket, it enters a state where it is not able to completely boot anymore. It stops after probing ue0 and after recognising the keyboard. It is not a hang, since if I press ctrl+alt+canc it does a clean reboot, but it just stops the boot there, as if it's waiting for something that is not probing. In a normal boot sequence, after the messages I see there would be ue0 going down, then up, and then I would get the login prompt. If anyone is willing to have a look, I can setup access to a serial console connected to the module. Ciao! -- Massimiliano Stucchi MS16801-RIPE _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"