Raspberry Pi 3 Building arm.armv7 12.2 w/Crochet

I'm attempting to build a 32 bit 12.2 release for the raspberry pi3 with
crochet.

Any help would be appreciated.

Motivation:  build a 32 bit couchdb3 (works on raspbian - debian 10.4
Buster), the pkg install of couchdb3 on aarch64 does not stay up...guessing
it is running out of memory on a 64 bit system with only the 1G pi3.

My development host is a 32 bit 12.2 release intel.
- pkg rpi-firmware version:  1.20210201.g20210201_1
- pkg u-boot-rpi3-32 version:  2020.10
- board_setup RaspberryPi3
- board/RaspberryPi3/setup.sh
  - TARGET=arm
  - TARGET_ARCH=armv7
  - KERNCONF=GENERIC
  - RPI3_UBOOT_PORT="u-boot-rpi3-32"
  - RPI3_UBOOT_BIN="u-boot.bin"
  - RPI_FIRMWARE_PORT="rpi-firmware"
- config.txt
  - init_uart_clock=3000000
  - enable_uart=1
  - kernel=u-boot.bin
  - kernel7=u-boot.bin
  - dtoverlay=mmc
  - dtoverlay=pi3-disable-bt


When the PI3 boots, I get past the rainbow screen, but the result is:

FreeBSD EFI Boot block
Loader path:  /boot/loader.efi
Initializing modules:  ZFS UFS
Load Path: /efi\boot\bootarm.efi
Load Device: /VenHw(e61d73b9-
Probing 3 block devices...not supported
not supported
not supported
done
ZFS found no pools
UFS found no partitions
Failed to load '/boot/loader.efi'
panic: No bootable partitions found!
## Application failed, r = 1
EFI LOAD FAILED: continuing...
MMC Device 1 not found
no mmc device at slot 1

U-Boot> version
U-Boot 2020.10 (Feb 06 2021 - 10:34:18 +0000)
arm-none-eabi-gcc (FreeBSD Ports Collection for armnoneeabi) 8.4.0
GNU 1d (GNU Binutils) 2.33.1
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-arm
To unsubscribe, send any mail to "[email protected]"