genet0 on raspberry4 working?
Denis Ahrens <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
Hi I use a raspberry pi 3 as a router/firewall for my DSL setup. UE0 for internal network and a USB device UE1 for the PPPOE with mpd5. For IPv6 I use dhcpcd. Everything works fine without problems. Now I tried to switch to a raspberry 4 with FreeBSD 13 BETA4 and it works for the ipv4 part but not for ipv6. I can ping ipv6 addresses. But everything else does not work. I can see the packets, but somehow they are corrupt or something. Since I use interface naming, I only changed two lines in my rc.conf from the raspi3 to the raspi4. So it is not a misconfiguration I think. I also tried to turn off RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6, but that did also not help. Has anybody experienced the same or is genet0 not quite ready yet? Denis PS: When I switch the devices genet0 does not work with the DSL modem either. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"