Re: RPI4 clock speeds and serial port ( temperatures idle and -j4 buildworld buildkernel )
Klaus Cucinauomo via freebsd-arm <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
>> >>>> Am 19.03.2021 um 18:43 schrieb bob prohaska <[email protected]>: >>> > I've enabled powerd and rebooted, console messages report that powerd > started with no explicit errors. A -j4 buildworld is running now. > > Should I expect to see powerd mess up the default mini-uart serial console? > So far, it hasn't with top reporting less than 1% idle. That's confusing.... > > Thanks for writing! > > bob prohaska normally shouldn‘t mess up the console.... sysctl dev.cpu.0.freq ... cpu.1.freq etc. prints the current freq -j4 shown c++ with ‚top‘ should run @ approx. 97% CPU-usage while ‚make‘ uses bit less Regards K. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"