Re: JMicron jms561 umass on arm64?
bob prohaska <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On Thu, Apr 08, 2021 at 02:00:29AM -0700, Mark Millard via freebsd-arm wrote: > > > I expect that until you have the above RPi firmware build > in place on the firmware-boot-stage media, all other > efforts are going to be messed up by the older firmware. > (I've no clue if the RPi firmware is a sufficient fix by > itself for your context even with a modern FreeBSD > relateive to what was fixed, but the RPi firmware likely > is a necessary part of the overall fix.) > I forgot to mention that before initially booting FreeBSD on my Pi4B I booted it with RasPiOS and ran sudo apt update/upgrade. That likely fixed the firmware on the Pi without intelligent intervention. At that point FreeBSD-14.0-CURRENT-arm64-aarch64-RPI-20210304-483c6da3a20-257149.img booted without memorable problems. HTH, bob prohaska > Note the lack of referencing u-boot in the above: so far > as I know u-boot was working fine over the time that > the RPi firmware was badly behaved, not that such was > obvious at the time. It just did not need to be changed > from what was officially built over the time frame. > > === > Mark Millard > marklmi at yahoo.com > ( dsl-only.net went > away in early 2018-Mar) > > _______________________________________________ > [email protected] mailing list > https://lists.freebsd.org/mailman/listinfo/freebsd-arm > To unsubscribe, send any mail to "[email protected]" _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arm To unsubscribe, send any mail to "[email protected]"