Re: HoneyComb first-boot notes

> >> I put an existing FreeBSD Optane into a just delivered
> >> HoneyComb, put in the RAM and the matching UEFI/ACPI
> >> image on a microsd card and put the card in the slot.
> >> I plugged in a USB3 Ethernet dongle, like I use on some
> >> other systems. Serial console via its USB port for such.
> >> (Optane instead of video card.) The UEFI/ACPI image was
> >> extracted from:
> >>
> >> https://solid-run-images.sos-de-fra-1.exo.io/LX2k/lx2160a_uefi/lx2160acex7_2000_700_2900_8_5_2_sd_81b4bbe.img.xz
> >>
> >> in order to match the RAM and being based on the
> >> most current vintage at:
> >>
> >> https://github.com/SolidRun/lx2160a_uefi/
> >>
> >> It booted.
> >
> > Could you share whole dmesg?
>
> I've not done a "boot -v" . The below is actually from a
> captured serial console output. It is lightly edited. I
> have omitted nearly all loader output (and before).
>

Thanks for sharing. Have you seen somewhere in output from UEFI (before
the loader) that "DPAA2 Management Complex initialized"?

Regards,
Dmitry