Re: HoneyComb first-boot notes
Mark Millard via freebsd-arm <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On 2021-Jun-22, at 01:31, Dmitry Salychev <dsl at mcusim.org> wrote: > >>>> I put an existing FreeBSD Optane into a just delivered >>>> HoneyComb, put in the RAM and the matching UEFI/ACPI >>>> image on a microsd card and put the card in the slot. >>>> I plugged in a USB3 Ethernet dongle, like I use on some >>>> other systems. Serial console via its USB port for such. >>>> (Optane instead of video card.) The UEFI/ACPI image was >>>> extracted from: >>>> >>>> https://solid-run-images.sos-de-fra-1.exo.io/LX2k/lx2160a_uefi/lx2160acex7_2000_700_2900_8_5_2_sd_81b4bbe.img.xz >>>> >>>> in order to match the RAM and being based on the >>>> most current vintage at: >>>> >>>> https://github.com/SolidRun/lx2160a_uefi/ >>>> >>>> It booted. >>> >>> Could you share whole dmesg? >> >> I've not done a "boot -v" . The below is actually from a >> captured serial console output. It is lightly edited. I >> have omitted nearly all loader output (and before). >> > > Thanks for sharing. Have you seen somewhere in output from UEFI (before > the loader) that "DPAA2 Management Complex initialized"? The text "DPAA2" does not occur in the captured output at all. However, that is my understanding of the expected status. === Mark Millard marklmi at yahoo.com ( dsl-only.net went away in early 2018-Mar)