Re: llvm10 build failure on Rpi3

I just noticed that in several prior messasges I quoted the llvm-tblgen
command that generates the *.inc files with the odd contents instead
of the later compile that tried to use the output files in question.

This leaves open the possibility that I had incorrectly checked on if
the build had failed, the build possibly not having reached the part
that used the files as of when I declared it was past that point.

So I may need to rerun some tests.


Side note:

It llooks like http://www.zefox.org/~bob/swaplogs/poudrierellvm10.log
shows that you tried with:

Device          1K-blocks     Used    Avail Capacity
/dev/da0s2b       1048576    25784  1022792     2%
/dev/mmcsd0s2b    1048576    25124  1023452     2%
Total             2097152    50908  2046244     2%

A gather that the problem still occurred?

===
Mark Millard
marklmi at yahoo.com
( dsl-only.net went
away in early 2018-Mar)