Re: Problems with 4G Huawei stick & RPi3 after upgrading to 13.0

Hi,

I tend to run only release kernels on non-development systems, but maybe 
I could
try -stable as waiting for 13.1 might not be an option.

Here is usbconfig output (but it is from FreeBSD 12.2):
ugen0.1: <DWCOTG OTG Root HUB> at usbus0, cfg=0 md=HOST spd=HIGH 
(480Mbps) pwr=SAVE (0mA)
ugen0.2: <vendor 0x0424 product 0x2514> at usbus0, cfg=0 md=HOST 
spd=HIGH (480Mbps) pwr=SAVE (2mA)
ugen0.3: <vendor 0x0424 product 0x2514> at usbus0, cfg=0 md=HOST 
spd=HIGH (480Mbps) pwr=SAVE (2mA)
ugen0.4: <vendor 0x0424 product 0x7800> at usbus0, cfg=0 md=HOST 
spd=HIGH (480Mbps) pwr=ON (2mA)
ugen0.5: <vendor 0x1a86 USB2.0-Serial> at usbus0, cfg=0 md=HOST spd=FULL 
(12Mbps) pwr=ON (98mA)
ugen0.6: <HUAWEIMOBILE HUAWEIMOBILE> at usbus0, cfg=0 md=HOST spd=HIGH 
(480Mbps) pwr=ON (2mA)

I can probably get same output with 13.0 during weekend if I visit the 
site (it's 100 km away).
Unfortunately, I don't have same hardware available locally.

If I remember correctly there was no output on dmesg when modeswitch 
failed, but I'll have to check
that.

     Ari S.

On 1.10.2021 10.01, Hans Petter Selasky wrote:
> Hi,
>
> First of all make sure the kernel is 13-stable, and not 13.0 release.
>
> On 10/1/21 8:35 AM, Ari Suutari via freebsd-arm wrote:
>> What might be the problem here ?
>
> Can you show the output from "usbconfig" run as root.
>
> Also, what is printed in "dmesg" when you run usb_modeswitch?
>
> --HPS
>