Re: FreeBSD 13 on RPI4 : stuck at splash screen

Hi,


Just guessing. I assume you have connected a HDMI screen? It might be that the default output is on a serial console (which you don’t have connected).
Can you ssh to the RPI?
It is also possible to set some variables to choose the hdmi as output. 


Anyway. I don’t use hdmi on my rpi so I might be totally wrong here. 


Regards,
Ronald


Van: Mayuresh <[email protected]>
Datum: 26 februari 2022 17:02
Aan: [email protected]
Onderwerp: FreeBSD 13 on RPI4 : stuck at splash screen

> 
> 
> Hello,
> 
> I am new to FreeBSD for any architecture.
> 
> Was trying out FreeBSD 13 downloaded from here[1] on RPI4 8G device.
> However the device did not go past the splash screen.
> 
> As some web pages suggest (probably those were for RPI40), tried inserting
> the sd card into a USB adapter and tried booting from USB. But the device
> then shows "insert SD card" message.
> 
> I had dd'ed it on an sdcard. This operation looks ok as I am able to mount
> and examine the sdcard's boot partition on Linux.
> 
> The device normally runs Raspberry OS and is working fine.
> 
> Please suggest if there is something I could try.
> 
> 
> [1]
> https://download.freebsd.org/ftp/releases/arm64/aarch64/ISO-IMAGES/13.0/FreeBSD-13.0-RELEASE-arm64-aarch64-RPI.img.xz
> 
> -- 
> Mayuresh
> 
> 
> 
> 
>