Re: USB regression on Overdrive 1000
Hans Petter Selasky <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On 3/16/22 14:46, John F Carr wrote: > I updated my kernel from 13.0-STABLE from early December to 13.1-STABLE from yesterday and I am having USB problems on my Overdrive 1000 ARM box. I see some usb_msc_auto_quirk messages I haven't seen before and there is a long delay "Root mount waiting for: usbus0". It does boot eventually off of the internal drive, ada0, but it continues to spew USB errors to the console. It doesn't register a "CAMuhub0" device and it never finds the USB stick plugged into the external port which should appear as da0. Any ideas? > > dmesg output attached, "good" comes from "boot kernel.old". The if_msk error is probably caused by a mismatch between old kernel and new root filesystem. > > > CPU 3: ARM Cortex-A57 r1p2 affinity: 1 1 > Release APs...done > usbus0: 5.0Gbps Super Speed USB v3.0 > Trying to mount root from zfs:zroot/ROOT/default []... > ugen0.1: <(0x1b73) XHCI root HUB> at usbus0 > uhub0 on usbus0 > uhub0: <(0x1b73) XHCI root HUB, class 9/0, rev 3.00/1.00, addr 1> on usbus0 > ada0 at ahcich1 bus 0 scbus1 target 0 lun 0 > ada0: <Patriot P200 1TB S0424A0> ACS-2 ATA SATA 3.x device > ... > Root mount waiting for: usbus0 > usb_msc_auto_quirk: UQ_MSC_NO_GETMAXLUN set for USB mass storage device Generic Mass Storage Device (0x14cd:0x125d) > usb_msc_auto_quirk: UQ_MSC_NO_TEST_UNIT_READY set for USB mass storage device Generic Mass Storage Device (0x14cd:0x125d) > usb_msc_auto_quirk: UQ_MSC_NO_PREVENT_ALLOW set for USB mass storage device Generic Mass Storage Device (0x14cd:0x125d) > usb_msc_auto_quirk: UQ_MSC_NO_SYNC_CACHE set for USB mass storage device Generic Mass Storage Device (0x14cd:0x125d) > Root mount waiting for: usbus0 > xhci0: Resetting controller > Root mount waiting for: usbus0 > usbd_req_re_enumerate: addr=1, set address failed! (USB_ERR_TIMEOUT, ignored) > Root mount waiting for: usbus0 > ... > xhci0: Resetting controller > Hi, Can you cherry pick this commit: https://cgit.freebsd.org/src/commit/?id=33cbbf268f7d0f3daff0c2aa06836d932faf56a9 to your 13-stable and enable it in the loader either manually or in /boot/loader.conf: set hw.usb.xhci.dcepquirk=1 hw.usb.xhci.dcepquirk=1 --HPS