Re: RPi3 usb boot hang on stable/13
Mark Millard <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On 2022-Jul-2, at 09:58, bob prohaska <[email protected]> wrote: > Lately an RPi3 running stable/13 has started hanging on boot from USB > The disk is on a powered hub. > > When gracefully rebooted it ends with: > > ..... > MESS:00:00:03.166523:0: Device tree loaded to 0x4000 (size 0x63cd) > MESS:00:00:03.172180:0: uart: Set PL011 baud rate to 103448.300000 Hz > MESS:00:00:03.178716:0: uart: Baud rate change done... > MESS:00:00:03.182145:0: uart: Baud rate change done... > MESS:00:00:03.187830:0: gpioman: gpioman_get_pin_num: pin SDCARD_CONTROL_POWER not defined > MMC: mmc@7e300000: 1 > Loading Environment from FAT... OK > In: serial > Out: vidconsole > Err: vidconsole > Net: No ethernet found. > starting USB... > Bus usb@7e980000: scanning bus usb@7e980000 for devices... 6 USB Device(s) found > scanning usb for storage devices... 1 Storage Device(s) found > Hit any key to stop autoboot: 0 > > Device 0: That is U-Boot output. Looks like the output stopped before the load of even the FreeBSD loader: FreeBSD is not involved yet so it is not a FreeBSD problem. > At that point the console is unresponsive. Nasty. > The machine has a history of not always finding the USB disk, but this > appears to be new behavior. As with the disk discovery problem, the > error can be worked around by simple repetition. Once booted it's > stable but network response remains erratic. > > There's some indication that power-cycling the hard disk helps. > > At the moment uname -a reports > > FreeBSD pelorus.zefox.org 13.1-STABLE FreeBSD 13.1-STABLE #5 stable/13-n251597-7c500f98b8d: Fri Jul 1 21:52:12 PDT 2022 [email protected]:/usr/obj/usr/src/arm64.aarch64/sys/GENERIC arm64 But FreeBSD is not involved yet at the failure point. What vintage of U-Boot? # strings u-boot.bin | grep "U-Boot 20" === Mark Millard marklmi at yahoo.com