Re: Failed to execute custom kernels which where build on a RPi 4 operated by 13.1-RELEASE

On 2022-Jul-5, at 05:47, John Kennedy <[email protected]> wrote:

> On Mon, Jul 04, 2022 at 11:41:37PM -0700, Mark Millard wrote:
>> Note: I do my own builds, installs, and configuration
>> experiments. Do not expect my example outputs below to
>> necessarily match those for official builds.
>> 
>> For reference from my root-on-UFS aarch64 environment that boots
>> via U-Boot (not via EDK2 UEFI/ACPI):
> 
>  Gah.  There is so much more out there than RPI4 now for arm64 I didn't
> stop to wonder if bsdinstall set it up right.  I just reformatted
> /boot/efi and slapped the uboot stuff in there because that was the way
> the SDcard image was set up.  I left it as /boot/efi (vs /boot/msdos).
> 
>> # sysctl hw.fdt # Likely a RPi* specific sysctl name?
>> hw.fdt.serial-number: REPLACED
>> hw.fdt.compatible: raspberrypi,4-model-b brcm,bcm2711
>> hw.fdt.model: Raspberry Pi 4 Model B Rev 1.4
> 
> 	# sysctl hw.fdt
> 	hw.fdt.serial-number: <REDACTED>
> 	hw.fdt.compatible: raspberrypi,4-model-b brcm,bcm2711
> 	hw.fdt.model: Raspberry Pi 4 Model B Rev 1.5
> 
>  Aha, that is what I was looking for.  Wasn't even seeing that with
> hw-probe, and I wasn't going to interrupt the 12-hour llvm13 compile to
> reboot and see what I could with uboot yet.

I checked, and for EDK2 UEFI/ACPI the "sysctl -a" output does
not report such information under any name. The sysctl hw.fdt
output is empty for that type of boot context, for example.

>  There is this guy, Mark Millard, who writes these really good mailing
> list emails that makes me paranoid about uboot version mismatches.  :D
> 
>  I haven't even looked at the EEPROM firmware stuff.

Rev 1.5 RPi*'s do not have many valid "default" EEPROM
content alternatives yet: most are too old to be appropriate.

> Reading the list,
> it's all been such potential foot-cannon fodder seeing some people's
> issues I just knew it would be a potential problem, but happily it just
> worked as I would have hoped.
> 
>> I boot a RaspiOS64 microsd card for the related activity.
> 
>  Yeah, I haven't been doing that.
> 

===
Mark Millard
marklmi at yahoo.com