Installing 13.1 ARM on SSD
"Wall, Stephen" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <MN2PR09MB4667694B5C97EAFA1816901AEE829@MN2PR09MB4667.namprd09.prod.outlook.com> |
I am attempting to install FreeBSD/ARM 13.1 on a RPi4 with a USB3 SSD attached. Steps I’ve taken: - Used Raspberry Pi Imager to set the board to boot from USB first, SD card second - downloaded and burned FreeBSD 13.1 arm65-aarch64-RPI image - booted and run bsdinstall - selected ZFS - selected the USB SSD Installation ran to completion, but when I reboot without the SD card, I get a “Firmware not found” error message. Searching the web gives lots of results for linux, but I can’t find anything for FreeBSD. Has anyone successfully done an install like this, and can point me toward some resources that will get me straightened out? -- Stephen Wall Senior Staff Software Engineer 585.924.7550 [cid:[email protected]] REDCOM Laboratories, Inc. One Redcom Center Victor, NY 14564-0995 www.redcom.com<http://www.redcom.com>
image001.png
(image/png, 2.6 KB) - not displayed