wireguard, was: kernel: Fatal data abort - issue on rpi4

Hello,

thank you again for your advice and opinions. I purchased new SanDisk sd 
card and usb stick as well, just in case.

I have to say, that I diged a bit further and found out the RPI4B (4G 
RAM) becomes unresponsive right after I try to access it via wireguard 
vpn, or when I tried to access the rest of the wireguard vpn from the 
box. I disabled the wireguard service before weekend and the box has an 
uptime since.

So, has anybody had an issue with wireguard and rpi4?

thx,
Marek

On 8/18/22 01:03, John Kennedy wrote:
> On Wed, Aug 17, 2022 at 11:10:30AM +0200, Marek Soudny wrote:
>> Hello,
>>
>> I am quite new to arm/aarch64. I recently purchased rpi4, burned an
>> sdcard image and have been trying to run it. Time to time (but actually
>> quite often) the box becomes unresponsive. I can not ping it, neither
>> ssh into it. I am running fbsd 13.1-release.
> 
>    When I was doing a lot of SDcard work pre-RPI4, I was almostly
> exclusively using SanDisk (Ultra) cards.  I was looking for robust
> cards with high transfer speed.  Once USB became an option, I pretty
> only much booted off them when I was forced to.
>