Re: u-boot debug, was: Re: U-boot on RPI3, sees disk but won't boot it

> Am 27.09.2022 um 19:58 schrieb Klaus Küchemann <[email protected]>:
> 
> 
>> Am 27.09.2022 um 18:03 schrieb bob prohaska <[email protected]>:
>> 
>> I did look at common/usb.c but it's far from obvious how one
>> can turn on the logging feature so as to report more errors
>> to the console.
> 
> you can add the following to common/usb.c (e.g. insert in line 44):
> 
> #define DEBUG
> 
> --
> 
> that should then print out all debug functions inside the usb.c file to the console 
> after recompilation of u-boot.
> 
> Regards
> 
> Klaus

I saw there is  /*#include <log.h>*/ available in usb.c 
so you could also try to add :

#define LOG_DEBUG

to the common/usb.c file which should also then enable the debug functions
which then would be output in logging style.

You will need the debug output to to narrow down the issue.

just a guess : 
electrical problem(of the Pi itself)  which could perhaps be fixed by  manipulating the scan delay time .

Regards

Klaus