Re: u-boot debug, was: Re: U-boot on RPI3, sees disk but won't boot it
Mark Millard <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On 2022-Sep-27, at 16:29, bob prohaska <[email protected]> wrote: > On Tue, Sep 27, 2022 at 03:27:10PM -0700, Mark Millard wrote: >> . . . > . . . > U-Boot> usb reset > resetting USB... > Bus usb@7e980000: dwc2_usb usb@7e980000: Can't get reset: -2 > USB DWC2 > scanning bus usb@7e980000 for devices... 6 USB Device(s) found > scanning usb for storage devices... 1 Storage Device(s) found > U-Boot> > > Issuing > U-Boot> run bootcmd_usb0 > > Device 0: > > [tens of seconds pause, looks like u-boot started over] > > U-Boot 2022.04 (Sep 27 2022 - 15:47:57 -0700) . . . Do you have RPi* firmware debug output ennabled such that you would see messages from it if the RPi* firmware started over? In other words, can you tell if . . . A) The RPi* firmware and then U-Boot both restarted vs. B) Just U-Boot restarted, not the RPi* firmware? If you can tell, which was it? === Mark Millard marklmi at yahoo.com