FYI, RPi3B: da0 vs. pass0 for same USB media based on initial_turbo=60 in config.txt ?

With initial_turbo=60 in config.txt content used by RPi3B's
I get:

da0 at umass-sim0 bus 0 scbus0 target 0 lun 0
da0: <Samsung PSSD T7 Touch 0> Fixed Direct Access SPC-4 SCSI device
da0: Serial Number ***REPLACED***
da0: 40.000MB/s transfers
da0: 1907729MB (3907029168 512 byte sectors)
da0: quirks=0x2<NO_6_BYTE>

Without initial_turbo=60 being placed to be used by RPi3B's:
(so no initial_turbo assignment was made)

pass0 at umass-sim0 bus 0 scbus0 target 0 lun 0
pass0: <Samsung PSSD T7 Touch 0> Fixed Processor SCSI device
pass0: Serial Number ***REPLACED***
pass0: 40.000MB/s transfers

(The pass0 case does not end up with mount root working:
timeout results. For reference, the Serial Numbers did
match.)


In both cases, those lines are just after the text (diff
of serial console captures used to establish sameness):

uhub0: 1 port with 1 removable, self powered
ugen1.2: <vendor 0x0424 product 0x9514> at usbus1
uhub1 on uhub0
uhub1: <vendor 0x0424 product 0x9514, class 9/0, rev 2.00/2.00, addr 2> on usbus1
uhub1: MTT enabled
Root mount waiting for: usbus1 CAM
uhub1: 5 ports with 4 removable, self powered
ugen1.3: <vendor 0x0424 product 0xec00> at usbus1
smsc0 on uhub1
smsc0: <vendor 0x0424 product 0xec00, rev 2.00/2.00, addr 3> on usbus1
smsc0: chip 0xec00, rev. 0002
miibus0: <MII bus> on smsc0
smscphy0: <SMC LAN8700 10/100 interface> PHY 1 on miibus0
smscphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
ue0: <USB Ethernet> on smsc0
ue0: Ethernet address: ***REPLACED***
Root mount waiting for: CAM
Root mount waiting for: CAM
usb_msc_auto_quirk: UQ_MSC_NO_GETMAXLUN set for USB mass storage device Samsung PSSD T7 Touch (0x04e8:0x4001)
ugen1.4: <Samsung PSSD T7 Touch> at usbus1
umass0 on uhub1
umass0: <Samsung PSSD T7 Touch, class 0/0, rev 2.10/1.00, addr 4> on usbus1
umass0:  SCSI over Bulk-Only; quirks = 0x0100
umass0:0:0: Attached to scbus0
Root mount waiting for: CAM
Root mount waiting for: CAM
Root mount waiting for: CAM
Root mount waiting for: CAM
Root mount waiting for: CAM


===
Mark Millard
marklmi at yahoo.com