Re: u-boot debug, was: Re: U-boot on RPI3, sees disk but won't boot it

I've put the full output from a failed (no storage
device found) attempt at
http://www.zefox.net/~fbsd/rpi3/u-boot/u-boot-debug-log

The obvious error message is:
Cannot enable port 1 after 5 retries, disabling port.
Nothing about device 152d.

Tomorrow I'll try to capture a complete log of a 
successful boot for comparison. The boot success
rate is so far is 7 in 9 or 10, depending on how
one counts. 

Thanks for all your help!

bob prohaska