Re: u-boot debug, was: Re: U-boot on RPI3, sees disk but won't boot it

bob prohaska <[email protected]>
Newsgroups gmane.os.freebsd.devel.arm
Message-ID <[email protected]>
An odd occurrence not seen before, perhaps because
I never waited long enough.

The console reported:

U-Boot 2022.04 (Oct 02 2022 - 09:46:36 -0700)

DRAM:  948 MiB
RPI 3 Model B (0xa02082)
Core:  69 devices, 10 uclasses, devicetree: board
MMC:   mmc@7e300000: 2
Loading Environment from FAT... In:    serial
Out:   vidconsole
Err:   vidconsole
Net:   No ethernet found.
starting USB...
Bus usb@7e980000: USB DWC2
scanning bus usb@7e980000 for devices... error in inquiry
6 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot:  0 
MMC Device 0 not found
no mmc device at slot 0
MMC Device 1 not found
no mmc device at slot 1
Card did not respond to voltage select! : -110

Device 0: unknown device
missing environment variable: pxeuuid
Retrieving file: pxelinux.cfg/01-b8-27-eb-ba-68-d5
Retrieving file: pxelinux.cfg/00000000
Retrieving file: pxelinux.cfg/0000000
Retrieving file: pxelinux.cfg/000000
Retrieving file: pxelinux.cfg/00000
Retrieving file: pxelinux.cfg/0000
Retrieving file: pxelinux.cfg/000
Retrieving file: pxelinux.cfg/00
Retrieving file: pxelinux.cfg/0
Retrieving file: pxelinux.cfg/default-arm-bcm283x-rpi
Retrieving file: pxelinux.cfg/default-arm-bcm283x
Retrieving file: pxelinux.cfg/default-arm
Retrieving file: pxelinux.cfg/default
Config file not found
U-Boot> usb reset
resetting USB...
Bus usb@7e980000: USB DWC2
scanning bus usb@7e980000 for devices... 6 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
U-Boot> run bootcmd_usb0

[a few seconds elapsed]

Device 0: [ few minutes] Vendor: SABRENT  Rev: 0214 Prod: 
            Type: Hard Disk
            Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512)
... is now current device

[tens of minutes elapsed]

** No partition table - usb 0 **
Couldn't find partition usb 0:1
U-Boot> 
U-Boot> 
U-Boot> 
U-Boot> 
U-Boot>     

I thought it was stuck, but apparently not.

It's still unbootable.

Not sure it's relevant, but certainly a surprise to me.

bob prohaska
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.