FreeBSD 14.0-RELEASE and Raspberry Pi CM4 4GB

Steve Bernacki <[email protected]>
Newsgroups gmane.os.freebsd.devel.arm
Message-ID <[email protected]> 
I recently purchased a RPI CM4 with 4GB and 32GB eMMC to replace my 
aging FreeBSD firewall. I managed to install FreeBSD 14.0-RELEASE-p3 on 
it, and both Ethernet devices (genet0 and ue0) were properly identified. 
However, network throughput on my gigabit network is pretty bad; iperf3 
reports a maximum transfer speed of 291 Mbits/sec. Flashing OpenWRT on 
the same hardware using the same ethernet port, I'm able to achieve 923 
Mbits/sec.

Does anyone have any suggestions on how to improve throughput under FreeBSD?

Thank you
Steve
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.