Re: When will FreeBSD support RPI5?
Mark Millard <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On Jan 13, 2024, at 07:38, Doug Rabson <[email protected]> wrote: > Getting back to the RPI 5, with a tweak to arm/broadcom/bcm2835bcm2835_vcbus.c to treat the memory config the same as RPI 4 and to dev/sdhci/sdhci_fdt.c to treat the RPI 5 sdhci controllers as generic, I can boot to multiuser mode using the EDK2 firmware from https://github.com/worproject/rpi5-uefi with ACPI/Device Tree mode set to Both. What does FreeBSD do with "Both"? Does it actually use some ACPI and some Device Tree? Or does it just use ACPI? Does your combination do anything different than just using ACPI? > This does not have working PCIe or ethernet yet - I think ethernet ought to work since we seem to have a matching driver in the tree in dev/cadence. Sounds like the same status as booting just ACPI with no such adjustments too bcm2835bcm2835_vcbus.c or sdhci_fdt.c ? I think Mike Karels plans on investigating getting Ethernet going based on cgem . I've no clue if this is ACPI, DeviceTree, or both. My usage has been pure ACPI, no software adjustments specific to getting the RPi5 operational. Use of a USB3 Ethernet dongle. === Mark Millard marklmi at yahoo.com