Re: When will FreeBSD support RPI5?

On Tue, 16 Jan 2024 14:57:40 +0000
Doug Rabson <[email protected]> wrote:

> On Sat, 13 Jan 2024 at 19:05, Mike Karels <[email protected]> wrote:
> 
> > On 13 Jan 2024, at 12:32, Mark Millard wrote:
> >
> > > On Jan 13, 2024, at 07:38, Doug Rabson <[email protected]> wrote:
> > >
> > >> Getting back to the RPI 5, with a tweak to
> > arm/broadcom/bcm2835bcm2835_vcbus.c to treat the memory config the same as
> > RPI 4 and to dev/sdhci/sdhci_fdt.c to treat the RPI 5 sdhci controllers as
> > generic, I can boot to multiuser mode using the EDK2 firmware from
> > https://github.com/worproject/rpi5-uefi with ACPI/Device Tree mode set to
> > Both.
> > >
> > > What does FreeBSD do with "Both"? Does it actually use some ACPI
> > > and some Device Tree? Or does it just use ACPI? Does your
> > > combination do anything different than just using ACPI?
> > >
> > >> This does not have working PCIe or ethernet yet - I think ethernet
> > ought to work since we seem to have a matching driver in the tree in
> > dev/cadence.
> > >
> > > Sounds like the same status as booting just ACPI with no such
> > > adjustments too bcm2835bcm2835_vcbus.c or sdhci_fdt.c ?
> > >
> > > I think Mike Karels plans on investigating getting Ethernet
> > > going based on cgem . I've no clue if this is ACPI, DeviceTree,
> > > or both.
> >
> > The cadence/cgem driver uses FDT.  I haven't looked at details yet.  The
> > addition
> > might be as simple as adding a compat string.  Hopefully it doesn't
> > require major
> > surgery.  I just ordered an RPi 5 (8 GB); it will take a while to be
> > delivered.
> >
> 
> The existing driver has the correct compat string but we don't get that far
> since the rp1 node doesn't get probed and attached. This node is nested
> under pcie@120000 and the whole subtree never gets explored. Interestingly,
> if I hack the 2711 driver a little (based on reading Linux sources), I can
> get that to attach and the rp1 southbridge is visible on the PCI bus with
> vendor id 0x1de4, device id 0x0001. I made a stub driver for it but that
> isn't particularly helpful since we need an FDT device to get simplebus to
> attach and discover all the rp1 sub-devices.

 Why is there FDT children under a pci device ???

> I could try to add any ofw children to the pcie device, I guess. By the
> looks of things, that just needs me to implement ofw_bus_get_devinfo and
> maybe bus_get_resource_list in the pcie driver. Reading the DTB sources,
> the 2711 pcie separates out the MSI part as a separate node in the DTB
> which will need a driver before we can get much further.


-- 
Emmanuel Vadot <[email protected]> <[email protected]>