Re: local/etc/rc.d service that runs before date being set by ntpd

Van: Nuno Teixeira <[email protected]>
Datum: woensdag, 27 maart 2024 10:55
Aan: FreeBSD ARM List <[email protected]>
Onderwerp: local/etc/rc.d service that runs before date being set by ntpd
> 
> Hello all,
> 
> On rpi4 I use a service dns/noip and found that it don't get actual date from ntpd:
>  
> /var/log/daemon.log (today) after boot
> ---
> <snip>
> Mar 27 09:09:40 rpi4 dhclient[1183]: DHCPREQUEST on genet0 to 192.168.1.1 port 67
> Mar 27 09:09:40 rpi4 dhclient[1183]: DHCPACK from 192.168.1.1
> Mar 27 09:09:40 rpi4 dhclient[1183]: bound to 192.168.1.66 -- renewal in 1800 seconds.
> Jan  1 01:00:34 rpi4 noip2[1617]: v2.1.9 daemon started with NAT enabled
> Jan  1 01:00:35 rpi4 noip2[1617]: freebsdrpi4.hopto.org was already set to 149.90.156.215.
> <service noip restart>
> Mar 27 09:26:13 rpi4 noip2[1617]: v2.1.9 daemon ended.
> Mar 27 09:26:13 rpi4 noip2[1887]: v2.1.9 daemon started with NAT enabled
> Mar 27 09:26:14 rpi4 noip2[1887]: freebsdrpi4.hopto.org was already set to 149.90.156.215.
> ---
> rcconf:
> ntpd_enable="YES"
> ntpd_sync_on_start="YES"
>  
> Checking `rcorder /etc/rc.d/* /usr/local/etc/rcd/*` have correct order (?):
>  
> <snip>
> /etc/rc.d/ntpdate
> ...
> /etc/rc.d/sdpd
> /etc/rc.d/rarpd
> /etc/rc.d/powerd
> /etc/rc.d/ntpd
> /etc/rc.d/nscd
> /usr/local/etc/rc.d/dbus
> /usr/local/etc/rc.d/git_daemon
> /usr/local/etc/rc.d/noip
> /etc/rc.d/rfcomm_pppd_server
> /etc/rc.d/mountd
> /etc/rc.d/swaplate
> ...
> Strange that noip doesn't get correct date at boot time.
>  
> Do I missing something?
>  
> Thanks!
>  
> --
> Nuno Teixeira
> FreeBSD Committer (ports)


Hi,

In my rcorder output noip2 comes before ntpd.
But I have in rc.conf:
ntpdate_enable="YES"
ntpd_enable="YES"

ntpdate is run more early in the rcorder.

I don't know about ntpd_sync_on_start and if that influences the rcorder. I think it is just an option to ntpd.

Please try to add ntpdate_enable="YES".

BTW: if you run ZFS-on-boot on RPI you can use sysutils/fakertc to get a bit better time at boot. In UFS the time is stored on disk on unmount/shutdown which is used to set the time on startup. ZFS does not have this feature. Fakertc mimics this as good as it can which can help to have a "decent" time to make TLS certificates, etc. valid on boot.

Regards,
Ronald.