Re: Raimbow screen installing / booting FreeBSD-14.2-RELEASE-arm64-aarch64-RPI.img on the raspberry pi zero 2w

On Feb 4, 2025, at 17:39, Mario Marietto <[email protected]> wrote:

> ----> A better alternative experiment would likely be to:
> 
> I did :
> 
> marietto# cp bcm2710-rpi-3-b.dtb bcm2710-rpi-zero-2-w.dtb
> 
> and the board booted wonderfully without one only problem.
> 
> I think that it's a good idea to add a note on the bug report that the patches created don't work and that the fix,for the moment is :
> 
> marietto# cp bcm2710-rpi-3-b.dtb bcm2710-rpi-zero-2-w.dtb

Why not try sysutils/rpi-firmware and copying over the
/usr/local/share/rpi-firmware/bcm2710-rpi-zero-2-w.dtb
that is actually for the RPi* that you have? It is the
same vintage of materials as is on the official media.

If it does not work, that would be good to have in the
notes as well. Similarly, if it does work it would be
good to have that noted.

===
Mark Millard
marklmi at yahoo.com