Re: Raimbow screen installing / booting FreeBSD-14.2-RELEASE-arm64-aarch64-RPI.img on the raspberry pi zero 2w

On Wed, Feb 5, 2025 at 2:59 AM Mark Millard <[email protected]> wrote:
> On Feb 4, 2025, at 17:39, Mario Marietto <[email protected]> wrote:
> > ----> A better alternative experiment would likely be to:
> > I did :
> > marietto# cp bcm2710-rpi-3-b.dtb bcm2710-rpi-zero-2-w.dtb
> > and the board booted wonderfully without one only problem.
> > I think that it's a good idea to add a note on the bug report that the patches created don't work and that the fix,for the moment is :
> > marietto# cp bcm2710-rpi-3-b.dtb bcm2710-rpi-zero-2-w.dtb
>
> Why not try sysutils/rpi-firmware and copying over the
> /usr/local/share/rpi-firmware/bcm2710-rpi-zero-2-w.dtb
> that is actually for the RPi* that you have? It is the
> same vintage of materials as is on the official media.
>
> If it does not work, that would be good to have in the
> notes as well. Similarly, if it does work it would be
> good to have that noted.

Yup, I can confirm rpi-firmware/bcm2710-rpi-zero-2-w.dtb works with
FreeBSD-14.2-RELEASE-arm64-aarch64-RPI.img :-)

One thing to mention too is config_rpi3.txt -> config.txt (not
config_rpi_0_w.txt) :-)

Thanks!! :-)

ps/2: pkg does not update because of certificate errors, but
freebsd-update fetch install went fine to 14.2-RELEASE-p1 o_O

-- 
CeDeROM, SQ7MHZ, http://www.tomek.cedro.info