Re: Nanopi R5S and U-boot from Ports

>> On 11 Feb 2025, at 13.12, Nenhum_de_Nos <[email protected]> wrote:
>>
>>>
>>> Hi,
>>>
>>> On Mon, 10 Feb 2025 23:05:01 -0000
>>> "Nenhum_de_Nos" <[email protected]> wrote:
>>>
>>>> Hi,
>>>>
>>>> have anyone ever tested this router and got to have all 3 NIC's?
>>>>
>>>> I am trying to use the u-boot r5s package from pkg, as opposed to
>>>> using
>>>> edk2 firmware. Using edk2 firmware I get all three NIC's.
>>>
>>> With edk2 you likely booted in acpi-mode while with u-boot you booted
>>> in fdt mode and if_re-kmod doesn't have fdt attachement.
>>>
>>> Cheers,
>>
>> Hi Emmanuel,
>>
>> so there is nothing I can do for now, but wait till the if_re driver to
>> work on ftd mode?
>>
>> thanks for the help.
>
> You are probably not getting the right DTB from u-boot Is my guess.
> If the two Realtek devices doesn’t show up in the pciconf -lv output
> that is most likely the case.
> Try to hardwire the DTS to rk3568-nanopi-r5s.dts, that should make it
> work.
>
> I use several of those boards and they work OK, granted with at modified
> src tree…

Soren,

provided I use the official package from FreeBSD for u-boot, how can I
assure I have the right one in the right place? Please excuse me for my
lack of arm arch knowledge. I did looked for the dts on the /boot dir on
the disk, and my guess at the time was there was the same that was used
for the package. Do I need to build myself from ports and then copy the
dts to some place specific to suit this case?

I am not at home now and the box is turned off, later I can spend some
time on it and report back here.

If helps, I got this on the dmesg:

rgephy0: <RTL8169S/8110S/8211 1000BASE-T media interface> PHY 0 on miibus0
rgephy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX,
1000baseT-FDX, 1000baseT-FDX-master, auto
rgephy1: <RTL8169S/8110S/8211 1000BASE-T media interface> PHY 1 on miibus0
rgephy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX,
1000baseT-FDX, 1000baseT-FDX-master, auto

Running u-boot.

thanks,

matheus