Re: Armv7 unresponsive with flashing disk light
Mark Millard <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.arm |
|---|---|
| Message-ID | <[email protected]> |
On Apr 25, 2025, at 16:12, Robert Clausecker <[email protected]> wrote: > Am Fri, Apr 25, 2025 at 02:46:58PM -0700 schrieb bob prohaska: >> A Pi2 running -current armv7 got stuck again during buildworld. >> No debugger escape was possible, despite repeated tries. Power >> cycle was followed by a normal boot. >> >> This time, the usb hard disk activity LED was pulsing steadily, >> roughly 3-5 Hz. That's new. Formerly all stoppages had no disk >> activity indications. > > That could be the kernel dumping itself. Did it eventually stop? Per that note: you (Bob) may want to let the light blink until its stops (or it has been a very long time) if such happens again in the future. Then you might have a crash dump to get information from once you do boot again. (This presumes you have things configured to have crash dumps enabled.) >> Thanks for reading, >> >> bob prohaska > > Yours, > robert Clausecker > === Mark Millard marklmi at yahoo.com