Re: How to boot FreeBSD installed on the sd card on the Khadas Edge-V instead of Android

Mario Marietto <[email protected]>
Newsgroups gmane.os.freebsd.devel.arm
Message-ID <CA+1FSigU2bFY=_PV-U2G=2c8T0hByaFYvGEjoa1CTq8d6u51oQ@mail.gmail.com>
I've followed the procedure explained here :
https://khadas.github.io/linux/edge/BootIntoUpgradeMode.htmlSo :Linux
Command Line

   1. Booted Android and installed the Terminal Emulator
   2. On Android, I have executed reboot loader.

The system rebooted but it didn't enter Upgrade Mode. The Led was frozen to
red and nothing happened anymore....


On Sun, Jul 6, 2025 at 11:11 PM Mario Marietto <[email protected]>
wrote:

> ---> Perhaps you try again with the Khadas-fn-button...
>
> On the Khadas docs there are two procedures that can be followed,but it's
> not clear what's the correct one. It regards how many times I should press
> the Fn button...
>
> 1)
> Keys Mode (U-Boot is Running Normally)
>
>    1. Power on Edge.
>    2. *Long press the Function key without releasing it.*
>
> 2)TST Mode (Recommended)
>
>
>    1. Power-on Edge.
>    2. *Quickly press the Function key 3 times in 2 seconds, then release
>    the key.*
>    3. You will see the Power-LED (Blue) blink for about 3 seconds. After
>    the Power-LED (Blue) turns OFF, this indicates that the board is in Upgrade
>    Mode (Maskrom Mode).
>
>
> 1 or 2 ?
>
>
> On Sun, Jul 6, 2025 at 10:38 PM Klaus Küchemann <[email protected]>
> wrote:
>
>> You’re welcome ,
>>
>> that`s normal behavior of RK3399 boards
>> to be forced to erase their default u-boot/OS from spi & emmc(if
>> available)..
>> Simply see it as normal OS-installation and take the time to get familiar
>> with it.
>> But right: the pin -short-circuit-thing  was easier on other boards, e.g.
>> on Rock960 there was a MaskRom button.
>> Perhaps you try again with the Khadas-fn-button...
>>
>> Good luck &
>> Best regards
>>
>> K.
>>
>> > Am 06.07.2025 um 22:27 schrieb Mario Marietto <[email protected]>:
>> >
>> > Thanks.
>> >
>> > I've already found it and read it,but I still don't know what to do
>> precisely. It's for this reason that I asked here. I'm very confused.
>> Thanks anyway.
>> >
>> > On Sun, Jul 6, 2025 at 10:21 PM Klaus Küchemann <
>> [email protected]> wrote:
>> >
>> >
>> > > Am 06.07.2025 um 22:08 schrieb Mario Marietto <[email protected]
>> >:
>> > >
>> > > Why have you suggested the most dangerous for a newbie ?
>> > >
>> >
>> > Hi Mario,
>> >
>> > I didn`t suggest anything and I don’t own a Khadas board, nor am I a
>> Khadas employee-
>> >
>> > But you asked for a link to instructions/manual from the vendor , so by
>> guessing you’re looking for this :
>> >
>> > https://khadas.github.io/linux/edge/index.html
>> >
>> >
>> > Regards
>> >
>> > K.
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> > --
>> > Mario.
>>
>>
>
> --
> Mario.
>


-- 
Mario.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.