Re: error loading rp1_eth - Re: Need testers for ALPHA RPi-5 fan control, GE NIC, WiFi drivers for FreeBSD-CURRENT

Van: void <[email protected]>
Datum: dinsdag, 2 juni 2026 15:41
Aan: [email protected]
Onderwerp: Re: error loading rp1_eth - Re: Need testers for ALPHA RPi-5 fan control, GE NIC, WiFi drivers for FreeBSD-CURRENT
> 
> On Tue, Jun 02, 2026 at 03:22:12PM +0200, Ronald Klop wrote:
> >
> >I get this error loading the ethernet module:
> >
> ># kldload rp1_eth
> >kldload: an error occurred while loading module rp1_eth. Please check dmesg(8) for more details.
> >
> >dmesg shows:
> >rp1_eth: root compatible does not match Pi 5 (raspberrypi,5-model-b or raspberrypi,5-compute-module) — refusing attach
> >module_register_init: MOD_LOAD (rp1_eth, 0xffff00012110d82c, 0) error 6
> 
> Hmm. My instance loads
> 
> 13    1 0xffff00011ed17000    2a000 rp1_eth.ko
> 
> It was loaded like this:
> 
> doas make load
> 
> I used https://github.com/aphor/FreeBSD15-RPi5-modules.git
> 
> OS is 16.0-CURRENT #0 n286096-490c53e9353f GENERIC-NODEBUG
> 
> what does 'make status' show from where you compiled/installed it?
> 
> here it says:
> 
> $ make status
> === Module Status ===
> BCM2712 Common Hardware:
>     bcm2712 is loaded
> RPi5 Board Support:
>     rpi5 is loaded
> RP1 Ethernet (Milestone 1):
>     rp1_eth is loaded
> 
> === sysctl Interface ===
>     hw.rpi5 sysctl available
>      hw.rpi5.fan.current_state: 2
>      hw.rpi5.fan.cpu_temp: 62800
>     hw.rp1_eth sysctl available
>      hw.rp1_eth.cfg.status_decoded: raw=0x00000000 link=DOWN speed=10M duplex=half
> 
> -- 
>  
> 
> 
> 

I think this is an indication of what is wrong.

# ofwdump -a
ofwdump: ioctl(..., OFIOCGETPROPLEN, ...) failed: Invalid argument
Node 0

But I don't know why this happens.

Regards,
Ronald.